|
Why Cycle?
Visit WhyCycle?
|
WORKSHOP
* All bikes are returned clean as part of service. Very dirty bikes incur a cleaning charge of £10.00
Seized Parts may incur an additional charge
Gold Service*: £150
Complete Overhaul. This is essentially a complete de-build and re-build, recommended as an annual service. This service consists of:
- Service Report - Comprehensive
- Comprehensive pre-service test
- Frame cleaned and checked for alignment and damage, threads cleaned and checked Disc mounts faced (if applicable)
- Drive chain (inc front and rear mech) – remove and clean full inspection, lubrication
- Wheel Check – remove, clean, check and lubricate bearings/hubs (if necessary), check spoke tension and true
- Headset - remove, check, cleaned, regreased
- Bottom Bracket - Removed, checked, cleaned, regreased
- All Other Components checked for wear, cleaned and re-lubricate
- Replace cables/hydraulic oil and re bleed
- New bar tape/grips
- Tyre check – correct pressure, signs of wear or damage
- Fork check – inspected for signs of wear or damage to seals cleaned and re-lubricated (service of forks or shocks extra)
- Brake check – Removed, checked, cleaned,
Silver Service*: £80 (exclusive of parts)
Performance Check. We recommend regularly used bikes have this level of service every 6 to 8 months or as part of pre-race preparation.
This service consists of:
- Service Report - Standard
- New tape/grips
- Pre-service test
- Brake check – inspection and adjustment
- Gear check – indexing and chain lubrication
- Skewer check – quick release/wheel nuts tightened
- Tyre check – correct pressure, signs of wear or damage
- Pedal check – Pedals removed greased and replaced
- Bolt check – including crank bolts/handle bars (correct Torque)
- Bleed brakes (if applicable)/new cables
- Drive chain – full inspection, lubrication and adjustment
- Bottom Bracket – inspect for wear
- Wheel Check – remove, check and lubricate bearings/hubs (if necessary), check spoke tension and true (if necessary)
- Frame – check for wear and damage
- Headset – check and tighten
- Cables – check for wear and damage, re-move and re-grease
Bronze Service*: £30 (exclusive of parts)
basic health and safety Check. We recommend cycles stored or unused over the winter have this level of service before use.
This service consists of:
- General visual inspection of cycle
- Brake check – inspection and adjustment (cables/hoses)
- Gear check – Cable inspection, indexing and chain lubrication
- Skewer check – quick release/wheel nuts tightened
- Wheel & Tyre check – correct pressure, signs of wear, damage and true
- Pedal check – tightened
- Bolt check – including crank bolts/handle bars (correct Torque)
- Drive chain – visual inspection, lubrication chain and cassette
- All moving parts lubed
Any bike repair job undertaken
No matter what your steed needs, our experienced team can take care of it; from truing your wheels to fitting new disc brake pads.
Suspension
Suspension units require regular care and attention in order for you to be able to get the full benefit from them. It is therefore absolutely essential that you have your suspension forks and rear shocks serviced every 3-12 months (dependent on use).
Due to the highly specialist nature of the work and the huge number of parts required all suspension servicing is carried out by a specialist contract service team. Your fork/shock needs to be booked in for its work – this can be done by calling 01922 411180. We will advise you of the timescales for the work including time for shipping to/from
If you would prefer for one of our mechanics to remove your shock or fork from your bike there will be a charge of £25 for removing and fitting and for storing the bike whilst the unit is being serviced
Suspension forks
The service includes:
Comprehensive pre-service test
Cleaning of the unit
Full strip down
Inspection of internal parts
Replacing all seals as necessary
Re-building with new oil/lubricant
Re-pressurisation of air forks
A comprehensive post-service test
Your fork will then be returned along with any replaced parts (for your inspection) and a technical report detailing the work undertaken.
Should any other parts need replacing (such as bushings) then there will be no further labour charge and only a charge for the additional parts. We will contact you for permission before fitting any additional parts.
Rear suspension
Our suspension experts can provide a service on Manitou, FOX and RockShox air sprung rear shocks.
The service includes:
- Full strip down, inspection and cleaning of the air/oil canister
- New seal kit fitted
- Shock lubricated
- Re-building of shock
- Re-pressurisation of shock
Your shock will then be returned along with any replaced parts (for your inspection) and a technical report detailing the work undertaken.
Should any other parts need replacing (such as bushings) then there will be no further labour charge and only a charge for the additional parts. We will contact you for permission before fitting any additional parts.
|